Frozen Screen Align

dmaximx5 · #1 (**permalink**) 04-02-2006, 06:54 PM

I have an X5 400 mHz and have had relatively few problems in almost 3 years. it recently was dropped and although landed softly in case, the touch screen has been unresponsive. i have done soft and hard resets, tried the repair on the ribbon cable and still no luck. it will reset to initial touch screen to align, but does not respond to anything past that. anyone have any other suggestions? thanks.

Drifter · #2 (**permalink**) 04-02-2006, 10:59 PM

Welcome to aximusers.com.

Take the motherboard and screen assembly out of the case and plug in the mains adapter. Switch on by operating the microswitch and they nee if you can get past the screen align.

If you cannot get past screen align in this state, check your ribbon cables to make sure they are pushed home fully. If you still cannot get past this, then I'm afraid its time for a new PDA.

If you can get past screen align when the unit is like this it could be that eithr your cable repair needs to be looked a again or something is pressing on the screen