|
I have got some problems about tapping on my Axim screen for a month.
Problems:
- The screen dose not respond properly (e.g. tap on the 'x' at the top right conner, but the "text input area" at the buttom left conner is activated).
- Fail to do screen alignment after a hard reset.
Cause of the problems:
- Deformation of the outer frame of Axim due to temperature changing. This makes an abnormal pressing on the rim of the screen, which causes the screen does not respond properly.
Procedure of a Solution:
- Remove two rubber feet at the top left and top right on the back of Axim.
- Adjust two screws under the rubbers feet. Actually, a little bit loosen the screws will reduce deformation of the frame. And, the touch screen will respond properly again.
Good luck everyone,
Rawichote.
|
Linear Mode
